Bezel blanks
To remove the bezel blanks:
1. Disconnect power from the system (
Pre-disassembly procedures on page 50) and remove the
front bezel (
Front bezel on page 58)
2. Remove the bezel blanks by squeezing in on the tabs (1) and pushing the bezel blanks out (2).
Figure 4-9 Removing the bezel blanks
Hood sensor (Smart Cover Sensor)
To remove the hood sensor:
1. Disconnect power from the system (
Pre-disassembly procedures on page 50) and remove the
access panel (
Access panel on page 57). Lay the workstation on its side with the system board
facing up.
2. Disconnect the white 1 x 3 hood sensor connector from the inline connector attached to the front
panel harness.
ENWW Removing and replacing components 59
To Next Page
Loading...
