2. For short or tall cards, lift the PCI retainer arm (1) with one hand, press in on the sides (2) of the
retainer, and rotate it (3) out of the chassis.
Figure 4-20 Removing the short or tall card PCI retainer
Installing the PCI retainer
1. Disconnect power from the system (
Pre-disassembly procedures on page 50), and remove the
access panel (
Access panel on page 57). Place the workstation on its side with the system board
facing up.
2. For short or tall PCI cards, attach the hooks of the PCI retainer (1) under the slots on the rear of
the chassis, and then rotate the retainer down until the retainer arm (2) supports the card.
Figure 4-21 Installing the short or tall card PCI retainer
ENWW Removing and replacing components 69
To Next Page
Loading...
