To Next Page

To Previous Page

Removing memory module

1. Disconnect power from the system ( Pre-disassembly procedures on page 50), and remove the

access panel (

Access panel on page 57). Place the workstation on its side with the system board

facing up.

CAUTION: To ensure that memory modules are not damaged during removal or installation,

power off the workstation and unplug the power cord from the AC power outlet. Wait until the LED

on the back of the power supply turns off before removing memory. If you do not unplug the power

cord while installing memory, your memory modules might be damaged and the system will not

recognize the memory changes.

2. Press the green tab at the base of the memory fan (1) and lift it up (2) to expose the memory

modules.

Figure 4-15 Rotating the memory fan

3. Gently push out on the socket levers.

ENWW Removing and replacing components 65

Other manuals for HP Xw8400 - Workstation - 4 GB RAM

Questions and Answers:

Need help?

Do you have a question about the HP Xw8400 - Workstation - 4 GB RAM and is the answer not in the manual?

General