To establish a setup password using workstation setup:
1. Power on or restart the workstation. In Windows, click Start>Turn off>Restart.
2. As soon as the computer is powered on, press and hold F10 until you enter the Computer Setup
(F10) Utility. Press Enter to bypass the title screen, if necessary.
NOTE: If you do not press the F10 key at the appropriate time, you must restart the workstation
and press and hold the F10 key again to access the utility.
If you are using a PS2 keyboard, disregard the keyboard error message that might appear.
3. Select Security>Setup Password, and follow the onscreen instructions.
4. Before exiting, select File>Save Changes and click Exit.
Establishing a power-on password in the Computer Setup (F10) Utility
Establishing a power-on password through the Computer Setup (F10) Utility prevents access to the
workstation when power is on, unless the password is entered. When a power-on password is set, the
Computer Setup (F10) Utility presents Password Options under the Security menu. The password
options include Network Server Mode and Password Prompt on Warm Boot.
When Network Server Mode is disabled, the password must be entered each time the workstation is
powered on when the key icon appears on the monitor. When Password Prompt on Warm Boot
is enabled, the password must also be entered each time the workstation is rebooted. When Network
Server Mode is enabled, the password prompt is not presented during POST, but any attached PS2
keyboard remains locked until the power-on password is entered.
To enable Network Server Mode, a power-on password must be set. The option then shows up
under Advanced>Password Options. This feature allows the system to boot without asking for the
power-on password, but the keyboard and mouse are locked until you enter it. The keyboard LEDs
rotate constantly when the system is in locked mode
To establish a power-on password through workstation setup:
1. Power on or restart the workstation. In Windows, click Start>Shut Down>Restart.
2. As soon as the computer is powered on, press and hold the F10 until you enter the Computer Setup
(F10) Utility. Press Enter to bypass the title screen, if necessary.
NOTE: If you do not press the F10 key at the appropriate time, you must restart the workstation
and press and hold the F10 key again to access the utility.
If you are using a PS2 keyboard, disregard the keyboard error message that might appear.
3. Select Security>Power-On Password, and follow the onscreen instructions.
4. Before exiting, select File>Save Changes and, Exit.
Entering a power-on password
To enter a power-on password:
1. Power on or restart the workstation. In Windows, click Start>Shut Down>Restart the
Computer.
2. When the key icon appears on the monitor, enter the current password, and press Enter.
NOTE: Type carefully. For security reasons, the characters you enter do not appear on the screen.
If you enter the password incorrectly, a broken key icon appears. Try again. After three unsuccessful
tries, you must restart the workstation, before you can continue.
40 Chapter 3 System management ENWW
To Next Page
Loading...
