Screen Message Probable Cause Recommended Action
211–Memory warning
condition detected.
An unknown issue with one of the
DIMMs has been detected.
CAUTION: Disconnect AC power from the
workstation before reseating or replacing components
because there is power to the system board even when
the workstation is powered down.
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace memory module if problem persists.
212–Failed Processor. Processor has failed to initialize. CAUTION: Disconnect AC power from the
workstation before reseating or replacing components
because there is power to the system board even when
the workstation is powered down.
1. Reseat the processor in its socket.
2. If the processor does not respond, replace it.
213–Incompatible ECC
Memory Module in memory
Socket(s).
The memory modules in the system
are either not all ECC, or not all non-
ECC. This could also be caused
because the DIMM is missing critical
SPD information.
CAUTION: Disconnect AC power from the
workstation before reseating or replacing components
because there is power to the system board even when
the workstation is powered down.
1. Verify that all memory modules are ECC or non-
ECC.
2. Replace memory module if problem persists.
214–DIMM Configuration
Warning.
DIMMs not installed correctly (not
paired correctly).
Refer to Memory on page 64“Memory” for the correct
memory configurations and reseat the DIMMs
accordingly.
301–Keyboard Error. Keyboard failure. 1. Reconnect keyboard with workstation
powered off.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
303–Keyboard Controller
Error.
I/O board keyboard controller. CAUTION: Disconnect AC power from the
workstation before reseating or replacing components
because there is power to the system board even when
the workstation is powered down.
1. Reconnect keyboard with workstation
powered off.
2. Replace the system board.
304–Keyboard or System Unit
Error.
Keyboard failure. CAUTION: Disconnect AC power from the
workstation before reseating or replacing components
because there is power to the system board even when
the workstation is powered down.
1. Reconnect the keyboard with workstation
powered off.
2. Be sure that none of the keys are pressed.
3. Replace keyboard.
4. Replace system board.
401–Parallel Port 1 Address
Assignment Conflict.
IRQ address conflicts with another
device.
Reset the IRQ in the BIOS Setup menu.
Table 5-18 POST error messages (continued)
ENWW POST error messages 129
To Next Page
Loading...
