HP Z220 SFF - HP Z820 Workstation Cabling Guidelines

HP Z820 Workstation cabling guidelines
See
HP Z820 Workstation system board components on page 33 to determine the location of system
board connectors.
NOTE: Port 0 is the default port for the boot drive (the default port can be changed manually in the
BIOS).
System board
connector
Drive configuration scenarios
1234
5
SATA RAID
5 only
6
SATA RAID
5 only
SAS 0 HDD 1 HDD 1 eSAS 2 HDD 1 — —
SAS 1 HDD 2 HDD 2 eSAS 2 HDD 2 — —
SAS 2 HDD 3 HDD 3 eSAS 2 HDD 3 — —
SAS 3 HDD 4 HDD 4 eSAS 2 HDD 4 — —
SAS 4 HDD 5 eSAS 1 eSAS 1 HDD 5 — —
SAS 5 HDD 6 eSAS 1 eSAS 1 HDD 6 — —
SAS 6 — eSAS 1 eSAS 1 ODD 1 ODD 1 —
SAS 7 — eSAS 1 eSAS 1 ODD 2 ODD 2 —
SATA 0 ODD 1 ODD 1 ODD 1 eSATA eSATA ODD 1
SATA 1 ODD 2 ODD 2 ODD 2 eSATA eSATA ODD 2
SCU 0 — — HDD 1 — HDD 1 HDD 1
SCU 1 — — HDD2 — HDD 2 HDD 2
SCU 2 — — HDD3 — HDD 3 HDD 3
SCU 3 — — HDD4 — HDD 4 HDD 4
eSAS 1 / eSAS 2 = external SAS (HP external SAS back panel or PCI bracket – 4 ports per cable assembly)
eSATA = external SATA (2 ports per cable assembly)
HDD = SATA or SAS hard disk drive
ODD = optical disc drive
NOTE: Only the most common configurations are shown here.
100 Chapter 3 Component Replacement Information and Guidelines