Configuring system BIOS
To set up a RAID configuration, the emulation mode must be set to RAID+AHCI in the Computer Setup
(F10) Utility. This is the default setting. If the mode has been changed, follow these steps to change it
back.
1. During startup, press F10 to enter the Computer Setup (F10) Utility.
2. Using the arrow keys, navigate to:
a. Desired language, then press Enter.
b. Storage > Storage Options, then press Enter.
c. SATA Emulation > RAID+AHCI, then press F10 to accept the new settings.
3. Navigate to:
a. Advanced > Power-On Options, then press Enter.
b. POST Messages > Enable, then press F10 to accept the new settings.
4. Navigate to:
a. Advanced > Device Options, then press Enter.
b. SATA RAID Option ROM Download, then press Enter.
c. Enable, then press F10 to accept the new settings.
5. Navigate to File > Save Changes and Exit, then press Enter.
6. Press Enter to accept the changes when prompted.
Configuring Intel SATA RAID
169
To Next Page
Loading...
