Table 2-2 Computer Setup (F10) Utility menu descriptions for the HP Z420, Z620, and the Z820
Workstations (continued)
Heading Option Description
Device Options Enables you to set the following device options:
●
Num Lock State at Power-On (On or Off)
●
S5 Wake-on-LAN (Enable or Disable)
●
Internal speaker—(Enable or Disable)
●
NIC Option ROM
1
Download (Enable or Disable)
●
NIC1 Option ROM
1
Download (Enable or Disable)
● SATA RAID Option ROM
1
Download (Enable/EFI/Disable)
●
SAS Option ROM
1
Download (Enable/EFI/Disable) (Not available on some
workstations.)
●
SCU Option ROM Download (Enable/EFI/Disable) (Not available on some
workstations.)
●
Multiprocessor (Activates a single core.)—(Enable or Disable)
●
Active Processor Cores—Selects a single core, or multiple cores per socket
●
Hyper-Threading—(Enable or Disable)
●
CECP Mode—(Enable or Disable)
Slot Settings Enable/disable the PCIe and PCI slots (1 - 7).
AMT
Configuration
Lets you set the following AMT (Intel Active Management Technology) configuration
options:
●
AMT (Enabled/Disabled)—Allows for remote discovery, repair and protection of
networked workstations. Enabling the AMT function also enables the Network
Controller (required for AMT to function correctly).
●
Unconfigure AMT/ME (Disabled/Enabled) 2—Restores AMT/ME defaults. When you
save and exit after enabling this option, you will be prompted to complete the process
upon restart. A Setup Password (even if one is set) does not need to be entered to
complete the process.
NOTE: Information about Intel AMT can be found at www.intel.com.
●
WatchDog Timer (Enabled/Disabled)—OS and BIOS WatchDog Timers can be set
independently (in minutes):
◦
OS WatchDog TimerTimer—Sets the OS WatchDog Timer
◦
BIOS WatchDog Timer—Sets the BIOS WatchDog Timer
1
Available on selected models
2
These options should be used by advanced users only
The Computer Setup (F10) Utility
59
To Next Page
Loading...
