To Next Page

To Previous Page

System Restore

If you have a problem that might be due to software that you installed on your computer, use System

Restore to return the computer to a previous restore point. You can also set restore points manually.

NOTE: Always use this System Restore procedure before you use the System Recovery feature.

NOTE: Some features might not be available on systems that are shipped without a Windows

operating system.

To start System Restore:

1. Close all open programs.

2. Click the Start button, right-click Computer, and then click Properties.

3. Click System protection, System Restore, click Next, and then follow the on-screen

instructions.

To add restore points manually:

1. Close all open programs.

2. Click the Start button, right-click Computer, click Properties, and then click System

protection.

3. Under Protection Settings, select the disk for which you want to create a restore point.

4. Click Create, and then follow the on-screen instructions.

34 Chapter 4 Setting up and restoring Windows 7

Questions and Answers:

Need help?

Do you have a question about the HP Z620 Series and is the answer not in the manual?

HP Z620 Series Specifications

General

Chipset	Intel C602
Memory	Up to 96GB DDR3 ECC
Graphics Options	NVIDIA Quadro or AMD FirePro
Power Supply	800W
Operating System	Windows 7, Windows 8, Linux
Dimensions	17.5 x 44.4 x 46.4 cm (6.9 x 17.5 x 18.3 in)
Networking	Integrated Gigabit Ethernet
Processor Options	Intel Xeon E5-2600 series (up to 8 cores)
Expansion Slots	7 slots (PCIe x16, PCIe x8, PCIe x4, PCI)