4. Remove the battery (see Battery on page 45).
5. Remove the service cover (see Service cover on page 47).
6. Remove the optical drive (see Optical drive on page 56) or upgrade bay hard drive (see Upgrade Bay
hard drive on page 58).
7. Remove the keyboard (see Keyboard on page 61).
8. Remove the top cover (see Top cover on page 71).
9. Remove the graphics board fan/heat sink assembly (see Graphics subsystem heat sink on page 96).
Remove the graphics board:
1. Remove the two Torx T8M2.5×4.0 screws (1) that secure the graphics board to the system board.
2. Lift the right edge of the graphics board until it rests at an angle (2), and then remove it from the
connector (3).
Reverse this procedure to install the graphics board.
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
