HPE Apollo 2000 Gen10 User Manual

12. Slide the power supply into the bay until it clicks into place.
Drive options
The different chassis options support SAS, SATA, and NVMe drives. For more information on drive
support, see Drive bay numbering.
IMPORTANT: Depending on the chassis configuration and the components installed in the servers,
it might be necessary to limit the number of drives installed in the chassis. For more information, see
"Temperature requirements" in the server user guide.
Hot-plug drive guidelines
When adding drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one drive is used, install it in the bay with the lowest device number.
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
54 Drive options

HPE Apollo 2000 Gen10 Specifications

General

Form Factor	2U
Maximum Number of Nodes	4
Management	HPE iLO 5
Processor Support	Intel Xeon Scalable processors
Power Supply	2 x 1600W Platinum Hot-Plug Power Supplies
Cooling	Hot-Plug Fans with N+1 Redundancy
Drive Bays	12 LFF or 24 SFF
Memory Capacity	Up to 3TB per node
Expansion Slots	3 PCIe 3.0 slots per node
Networking	Integrated 1GbE or optional 10/25GbE