Installing the Smart Storage Battery for the regular Power Supply
Procedure
1. If installing a Smart Storage Battery or redundant fan option, remove the access panel.
NOTE: After the Smart Storage Battery is installed, it might take up to two hours to charge. Features
requiring backup power are not enabled until the battery is fully charged.
NOTE: The Smart Storage Battery is supported with P408i-p and P408e-p controllers only. Due to
thermal concerns on some configurations, you are recommended to remove the Smart Storage
Battery if these two cards are not installed in the chassis.
2. To install the Smart Storage Battery, do the following:
34 Installing the Smart Storage Battery for the regular Power Supply
To Next Page
Loading...
