Specifications
Environmental specifications
Specification Value
Temperature range
1
—
Operating 10°C to 35°C (50°F to 95°F)
Non-operating -30°C to 60°C (-22°F to 140°F)
Relative humidity (noncondensing) —
Operating 8% to 90%
28°C (82.4°F), maximum wet bulb temperature
Non-operating
5% to 95%
38.7°C (101.7°F), maximum wet bulb temperature
1
All temperature ratings shown are for sea level. An altitude derating of 1.0°C per 305 m (1.8°F per 1000 ft) to 3050 m
(10,000 ft) is applicable. No direct sunlight allowed. Maximum rate of change is 20°C per hour (36°F per hour). The
upper limit and rate of change might be limited by the type and number of options installed.
For certain approved hardware configurations, the supported system inlet temperature range is extended:
• 5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level with an altitude derating of
1.0°C per every 175 m (1.8°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m
(10,000 ft).
• 40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 1.0°C per every 125 m (1.8°F
per every 410 ft) above 900 m (2953 ft) to a maximum of 3050 m (10,000 ft).
Mechanical specifications
HPE Apollo r2200 Gen10 Chassis
Specifications Value
Dimensions —
Height 8.76 cm (3.45 in)
Depth 87.93 cm (34.62 in)
Width 44.80 cm (17.64 in)
Weight (approximate values) —
Weight (maximum) 41.16 kg (90.75 lb)
Weight (minimum) 13.10 kg (28.89 lb)
HPE Apollo r2600 Gen10 Chassis
74 Specifications
To Next Page
Loading...
