HPE FlexNetwork 5130 24G 4SFP+ 1-slot HI - Mounting Bracket Kits; Rack-mounting by Using Front Mounting Brackets

8
Mounting bracket kits
Table 6 Mounting bracket kits for the HPE 5130 HI switches
Mounting bracket
kits
HPE 5130 24G 4SFP+ 1-slot HI
HPE 5130 48G 4SFP+ 1-slot HI
HPE 5130 24G PoE+ 4SFP+ 1-slot HI
HPE 5130 48G PoE+ 4SFP+ 1-slot HI
Front mounting
bracket kit
Provided Provided
Rear mounting
bracket kit
Not required Provided
Grounding cable Provided Provided
Figure 4 Front mounting bracket kit
(1) Hole for attaching the bracket to the switch chassis
(2) Hole for attaching the bracket to a rack
Figure 5 Rear mounting bracket kit
(1) Hole for attaching the bracket to a rack
(2) Load-bearing screw
Rack-mounting by using front mounting brackets
This task requires two people.
To install the switch in a 19-inch rack by using the front mounting brackets:
1. Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2. Determine the mounting position on the switch for the front mounting brackets.
1
2
1
2