HPE FlexNetwork 5130 24G 4SFP+ 1-slot HI - Configuration Terminal Display Problems; No Display; Garbled Display

42
3. Grasp the two handles of the fan tray with the side marked TOP facing up, and slide the fan tray
along the guide rails into the slot until the fan tray seats in the slot and has a firm contact with
the backplane.
Figure 45 Installing a fan tray
Configuration terminal display problems
If the configuration environment setup is correct, the configuration terminal displays booting
information when the switch is powered on. If the setup is incorrect, the configuration terminal
displays nothing or garbled text.
No display
Symptom
The PC displays nothing when the switch is powered on.
Solution
To resolve the problem:
1. Verify that the power supply is supplying power to the switch.
2. Verify that the console cable is correctly connected.
3. Verify that the console cable does not have any problems and the PC settings are correct.
4. If the problem persists, contact HPE Support.
Garbled display
Symptom
The display on the PC is garbled.
Solution
To resolve the problem:
1. Verify that the following settings are configured for the terminal:
 Baud rate—9,600.