60
Port mode LED (Mode) status Port LED status Description
Off No link is present on the port.
Flashing green (1 Hz) (PoE mode,
available only for HPE 5130 24G
PoE+ 4SFP+ 1-slot HI and HPE
5130 48G PoE+ 4SFP+ 1-slot HI
switches)
Steady green PoE power supply is normal.
Flashing green (3 Hz)
The device attached to the port requires
power higher than the maximum or
currently available PoE output power on
the port.
Steady yellow The port is experiencing a PoE failure.
Flashing yellow (3 Hz) POST has failed on the port.
Off The port is not supplying PoE power.
Flashing yellow (IRF mode) Steady green
The port status LED indicates the IRF
member ID of the switch. For example, if
the ports 1 to 5 are steady green, the IRF
member ID of the switch is 5.
SFP+ port LED
Table 24 SFP+ port LED description
SFP+ port LED status Description
Steady green
The port is operating at 10 Gbps. The port LED fast flashes when the port is
sending or receiving data.
Steady yellow
The port is operating at 1 Gbps. The port LED fast flashes when the port is
sending or receiving data.
Flashing yellow (3 Hz) POST has failed on the port.
Off
• No link is present on the port.
• The MODE LED operates in IRF mode.
• The MODE LED operates in PoE mode (for PoE switches only.)
Management Ethernet port LEDs
The switch provides an ACT/LINK LED to indicate the operating state of the management Ethernet
port.
Table 25 Management Ethernet port LED description
Management Ethernet port LED (ACT/LINK) status Description
Green The port is up.
Yellow The port is sending or receiving data.
Flashing yellow (3 Hz) The port has failed POST.
Off No link is present on the port.
To Next Page
Loading...
