HPE FlexNetwork 5130 24G 4SFP+ 1-slot HI - Power Supply Status LED; LED for the Port LED Mode (MODE)

58
Figure 55 SFP+ active optical cable
NOTE:
•
The fixed SFP+ ports on the switch do not support the HPE X130 10G SFP+ LC LRM
Transceiver, HPE X130 10G SFP+ LC LH 80km Transceiver, and HPE X130 10G SFP+ LC ER
40km Transceiver.
•
To guarantee the functionality of the SFP+ ports, use only HPE
SFP/SFP+ transceiver modules
and SFP+ cables.
•
The SFP/SFP+ transceiver modules and SFP+ cables available for the switch are subject to
change over time. For the most up-to-date list of SFP/SFP+ transceiver modules and SFP+
cables, consult your HPE sales representative or technical support engineer.
•
For the specifications for the HPE SFP/SFP+ transceiver modules and SFP+ cables, see HPE
Comware-Based Devices Transceiver Modules User Guide.
LEDs
System status LED
The system status LED shows the operating state of the switch.
Table 20 System status LED description
LED mark Status Description
SYS
Steady green The switch is operating correctly.
Flashing green (1 Hz) The switch is performing power-on self test (POST).
Steady red The switch has failed the POST or is faulty.
Flashing yellow (1 Hz) Some ports have failed to pass POST or are faulty.
Off The switch is powered off.
Power supply status LED
The switch provides two power supply slots at the rear. For each power supply, these switches
provide a power supply status LED on the front panel.