34 Connecting to the controller CLI port
Network ports on controller module A and controller module B are configured with the following factory-default IP settings:
• Management Port IP Address: 10.0.0.2 (controller A), 10.0.0.3 (controller B)
•IP Subnet Mask: 255.255.255.0
• Gateway IP Address: 10.0.0.1
If the default IP addresses are not compatible with your network, you must set an IP address for each network port using
the command-line interface.
Use the CLI commands described in the steps below to set the IP address for the network port on each controller module.
Once new IP addresses are set, you can change them as needed using the SMU.
NOTE: Changing IP settings can cause management hosts to lose access to the storage system.
1. From your network administrator, obtain an IP address, subnet mask, and gateway address for controller A, and
another for controller B.
Record these IP addresses so that you can specify them whenever you manage the controllers using the SMU or the CLI.
2. Use the provided USB cable to connect controller A to a USB port on a host computer. The USB mini 5 male
connector plugs into the CLI port as shown in Figure 20 (generic controller module is shown).
Figure 20 Connecting a USB cable to the CLI port
3. Enable the CLI port for subsequent communication.
If the USB device is supported natively by the operating system, proceed to step 4.
Linux customers should enter the command syntax provided in “Preparing a Linux computer for cabling to the
CLI port” (page 32).
Windows customers should locate the downloaded device driver described in “Preparing a Windows computer for
cabling to the CLI port” (page 33), and follow the instructions provided for proper installation.
CACHE
LINK
DIRTY
LINK
ACT
CLI
CLI
Host Interface
Not Shown
SERVICE−2
SERVICE−1
6Gb/s
Connect USB cable to CLI
port on controller faceplate
To Next Page
Loading...
