Removal and replacement procedures 38
9.
Disconnect the cable from the SPI board.
To replace the component, reverse the removal procedure.
Right bezel (UID/power/SID)
1. Power down the server (on page 26).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Extend the server from the rack (on page 26).
4. Remove the processor memory drawer (on page 29).
5. Using a Torx T-10 screwdriver, remove the screws securing the bezel to the chassis, and then
remove the assembly from the server.
To Next Page
Loading...
