Installing the drives
Procedure
1. Use the StoreOnce Management Console to check which drives are already installed in the storage
enclosure.
Go to Settings > Hardware Monitoring > Storage. Drill down to the individual drawers to see the list
of installed drives displayed with their disk bay locations.
2. Determine which drawer in the enclosure to populate with the set of additional 11 preconfigured disks.
For example, if you are installing the first capacity upgrade disk pack, the disks will go into drawer 2.
See Distributing the drives correctly. Be careful not to mix disks when handling multiple disk packs.
3. Open the hard drive drawer for the drawer. Pull the handle up (1) and out (2) to extend the drawer (3).
Figure 35: Opening the disk drawer
4. Pinch the levers (1) and remove the hard drive blank (2).
Figure 36: Removing the disk blank
5. Press the button (1) to release the carrier handle (2).
Installing capacity upgrade kits 105
To Next Page
Loading...
