HPE StoreVirtual 3200

Prepare for installation
Verifying the product contents
The following items are included with the HPE StoreVirtual 3200 Storage product. Verify that all items are
included before beginning the installation.
• 2U rack rail kit for each enclosure
• Array enclosure
• Drive enclosures
(if included in the product configuration)
• Disk drives and drive blanks as ordered
• Power cables
Additional tools and resources required
Make sure that the following items are available before beginning the installation.
• Any necessary system connect cabling that you purchased separately (Ethernet, iSCSI, Fibre
Channel)
NOTE:
10GBase-T lights out management connectivity requires Category 6 Ethernet cabling and
infrastructure. The patch cables have male RJ45 plugs on both ends. All of the cables, jacks,
connectors, and patch panels must be rated for Category 6 Ethernet. Category 6 and Category
6A patch cables have different maximum lengths.
• T-25 Torx or flat-head screwdriver
• Access to a workstation on the network
• Access to the Internet
• Necessary licensing
Preliminary tasks
All preliminary tasks should be performed before beginning the installation.
Procedure
• Determining who will install and configure the storage system
• Confirming support for your hardware and software
• Signing up to automatically receive advisories, notices, and other messages
16 Prepare for installation