Chapter 3 Scanning Mode
Manual Mode
In manual mode, when the trigger control interface of the scanner changes into trigger electrical level,
the scanner will start to shoot and read. In the limited time of “single reading time”, the scanner will
continuously shoot and read until it is successful. When trigger electrical level is canceled, or read is
over the single read time limit, shooting and reading will be stopped. When read is successful, the
scanner will output the editing content through communication interface. When start a new trigger
read, the host needs to cancel the trigger electrical level at first, and then send the trigger electrical
level after 20ms.
Manual Mode
Sense Mode
In automatic sensing mode, the scanner will monitor the images being taken. When the scene is
changed, it will read within the limited time of “single read time”. After reading the output
information successfully or time out, it will re-enter the state of monitoring scene change.
When the scanner works in this mode, it can also according to the trigger electrical level to enter the
reading state. After the trigger electrical level is canceled or reading times out, it will re-enter the
state of monitoring scene change. Before re-entering the monitoring state, the trigger electrical level
needs to be canceled, then it will be switched to the sensing mode.
Sensing Automatically
To Next Page
Loading...
Need help?
General
