Sensitivity
Normal (Default) Fast
Ultra-fast
Single Reading Time
In sensing reading mode, the parameter indicates the maximum time of allowing reading engine to
continuously collect and identify barcode before reading successfully. After reading successfully or
single read timeout, the reading engine will enter the interval of not collecting the read. The range of
single read time is 0.1~9.9s, step length is 0.1s. When set to 0, the read does not wait. Default time is
1s. Please refer to the Chapter 7 for the setting method.
Continuous Mode
Continuous mode means that the scanner continuously shoots, reads and output the information. In
this mode, the same barcode cannot be output.
Continuous
Single Reading Time Limit
In continuous mode, it indicates the maximum time of scanner continuously collect and identify
barcode before reading successfully. If it times out, it will enter the interval of not collecting and
reading according to the setting. The code reading time is 100ms in units, which can be set to 0.1~9.9s.
When it be set to 0 that indicates no waiting. Please refer to chapter 7 of the setting method.
To Next Page
Loading...
Need help?
General
