Not check (Default)
USS check OPCC check
Transmit check character:
Transmit check character Disable (Default)
Convert I 2 of 5 to EAN-13
Convert I 2 of 5 to EAN-13 Disable (Default)
Matrix 2 of 5
Enable/Disable Matrix 2 of 5
Enable Disable (Default)
Check and transmit character
Matrix 2 of 5 barcode data does not contain the check digit. If there is a check digit, it can be the
last one or two characters of the data. The check bit is the value calculated from all data to check
whether the data is correct. Therefore, if it is set to "Not check", the reader will normally transmit all
barcode data.
To Next Page
Loading...