1-bit check 2-bit check
Check bit algorithm
1 MSI MOD10/MOD10 (Default) 2 MSI MOD10/MOD11
Transmit check character
Transmit check character Disable (Default)
Interleaved 2 of 5
Enable/Disable Interleaved 2 of 5
Enable (Default) Disable
Check and transmit character
Interleaved 2 of 5 barcode data does not contain the check digit. If there is a check digit, it can
be the last one or two characters of the data. The check bit is the value calculated from all data to
check whether the data is correct. Therefore, if it is set to "Not check", the reader will normally
transmit all barcode data.
To Next Page
Loading...