HPRT N130BT - Timeout Setting of the same Barcode in Non-Single Scan Mode; Sensitivity; Center Aiming Decode Setting

N130BT User Manual
43
Timeout setting of the same barcode in non-single scan mode
Operand: 0x4F
Data:
0x00 indicates that there is no Timeout Invalid. If there is a barcode, it can still output.
0x01 indicates the timeout of 100ms.
0x63 indicates the timeout 9.9s.
Sensitivity
Operand: 0x51
Note: Ultra-fast mode in auto-sensing mode, the sensing distance of the scanning paper
barcode will be reduced significantly.
Normal (Default) Fast
Ultra-fast
Center aiming decode setting
Operand: 0x53
Variable
Data
0x00~0x63
Normal
Fast
Ultra-Fast
Data
0x00(Default)
0x01
0x02
Enable
Disable
Data
0x01(Default)
0x00