Connecting Rover to Mars
You can connect up to three assembled Rover modules to Mars at the same time.
Only two assembled Rover modules can be connected to Mars during camera calibration—
one for your camera, and one for the calibration board.
1.
Connect one end of a 15-m LAN cable to the Ethernet port on Rover.
2. Connect the other end of the 15-m LAN cable to an Ethernet port on Mars.
Do not connect any third-party devices to Mars using these Ethernet ports. Doing so will void
the warranty and may cause damage to Mars and any connected third-party devices.
16 System setup
To Next Page
Loading...
