lp-608 Rev. 000 Rel. 001 Date 3.15.18
2
The following dened terms are used throughout this manual to
bring attention to the presence of hazards of various risk levels or to
important product information.
DANGER indicates an imminently hazardous situation which, if not
avoided, will result in serious personal injury or death.
WARNING indicates a potentially hazardous situation which, if not
avoided, could result in personal injury or death.
CAUTION indicates a potentially hazardous situation which, if not
avoided, may result in moderate or minor personal injury.
CAUTION used without the safety alert symbol indicates a
potentially hazardous situation which, if not avoided, may result in
property damage.
NOTICE is used to address practices not related to personal injury.
Foreword
This manual is intended to be used in conjunction with other literature
provided with the water heater. This includes all related control
information. It is important that this manual, all other documents
included in this system, and additional publications including the
Code for the Installation of Heat Producing Appliances (latest version), be
reviewed in their entirety before beginning any work.
Installation should be made in accordance with the regulations of
the Authority Having Jurisdiction, local code authorities, and utility
companies which pertain to this type of water heating equipment.
Authority Having Jurisdiction (AHJ) – The AHJ may be a federal, state,
local government, or individual such as a re chief, re marshal, chief
of a re prevention bureau, labor department or health department,
building ocial or electrical inspector, or others having statutory
authority. In some circumstances, the property owner or his/her agent
assumes the role, and at government installations, the commanding
ocer or departmental ocial may be the AHJ.
NOTE: HTP reserves the right to modify product technical specications
and components without prior notice.
For the Installer
This water heater must be installed by qualied and licensed personnel.
The installer should be guided by the instructions furnished with the
water heater, and by local codes and utility company requirements.
Installations Must Comply With:
Local, state, provincial, and national codes, laws, regulations, and
ordinances.
The latest version of the National Electrical Code, NFPA No. 70.
Part 1 - General Safety Information
This water heater is approved for indoor installations only and is
not intended for use as a pool heater. Clearance to combustible
materials: 0” top, bottom, sides, and back. Heater must have room
for service: 24” front, 6” top, and 6” sides are minimum recommended
service clearances. (A combustible door or removable panel is
acceptable front clearance.) This water heater has been approved
for closet installation and installation on combustible ooring. Do
not install directly on carpeting. Install the water heater in a location
where temperature and pressure relief valve discharge or a leak will
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions to
reduce the risk of re, electric shock, or injury to persons should
be followed, including:
1. READ ALL INSTRUCTIONS BEFORE USING THIS WATER HEATER.
2. This water heater must be grounded. See Part 4 – Wiring, this
manual, for grounding details.
3. Install or locate this water heater only in accordance with the
provided installation instructions.
4. Use this water heater only for its intended use as described in
this manual.
5. Do not operate this water heater if it has been damaged or
dropped.
8. This water heater should be serviced only by qualied service
personnel. Contact the water heater installer or a qualied service
agency for examination, repair, or adjustment.
SAVE THESE INSTRUCTIONS
Table of Contents
Part 1 - General Safety Information 2
A. When Servicing the Water Heating System 3
B. Heater Water 3
C. Freeze Protection 3
D. Water Temperature Adjustment 3
Part 2 - Prepare the Water Heater 4
A. What’s in the Box 4
B. Locating the Water Heater 4
C. Water Chemistry Requirements 5
Part 3 - Piping 8
A. Plumbing 8
B. Thermal Expansion 8
C. Condensation 8
D. Insulation Blankets 8
E. Temperature and Pressure Relief Valve 8
F. Scalding 9
G. Filling the Heater 9
H. Applications 10
Part 4 - Wiring 10
A. Communication 10
B. Enabling the Lower Element 10
C. Field Wiring Details 10
Part 5 - Installation Checklist 12
Part 6 - Operation 12
A. Combination Thermostat and High Limit Control (ECO) 12
B. Upper Thermostat Adjustment and ECO Reset 12
C. Lower Thermostat Adjustment 13
D. Heating Element Replacement Procedure 13
Part 7 - Maintenance 14
Part 8 - Troubleshooting 16
Part 9 - Replacement Parts 17
Limited Warranty 18
Customer Installation Record Form 20
For Your Records
Write the Product Model and Serial Numbers:
Model # ___________________________________________
Serial # ____________________________________________
These numbers are listed on the product ratings label.
Keep this manual and information for future reference.
To Next Page
Loading...
Need help?
General
