To Next PageTo Next PageWhy does my HTP SSC-35 Water Heater T & P valve discharge?
The T & P valve on your HTP Water Heater might discharge due to a few reasons: the tank temperature being too high (lower the temperature on the tank), water expanding when heated (install an expansion tank), or the water pressure being too high (install a pressure reducing valve).
What to do if my HTP SSC-35 Water Heater has a rotten egg odor?
If your HTP Water Heater smells like rotten eggs, it is likely due to the supply water having a high sulfate or mineral content. To address this, check with a water quality specialist in your area and have your water supply analyzed. Then, address any water quality issues according to the specialist’s recommendations.
What to do if I have hot tubs, spas, multiple showers, or high demand with my HTP SSC-35 Water Heater?
If you're experiencing issues with hot tubs, spas, multiple showers, or high demand when using your HTP Water Heater, it could be due to several factors. The pressure might be too low, so check the line pressure for any restrictions. The tank recovery might be slow (slow startup boiler, see chart), or there might not be enough hot water (boiler sized too small, see chart). The demand might also be too great; in this case, check flow rates and compare them to the chart, and consider installing a mixing valve and/or flow restricting valve and raise the tank and boiler temperature.
What to do if my HTP SSC-35 Water Heater's supply water has high sulfate or mineral content?
If the supply water has high sulfate or mineral content in your HTP Water Heater, consult a water quality specialist in your area to analyze your water supply. Address any water quality issues based on the specialist's recommendations.
What to do if the circulator is not operating in my HTP SSC-35?
If the circulator in your HTP Water Heater is not operating, you should check it or replace it.
What to do if the wiring is incorrect in my HTP SSC-35?
If the wiring is incorrect in your HTP Water Heater, you should check the wiring.
General| Brand | HTP |
|---|---|
| Model | SSC-35 |
| Category | Water Heater |
| Language | English |
