Huawei 9000 - Switching between Screen Layouts

Procedure
Step 1 Tap
in the task bar to display the main menu and tap Control Camera.
Step 2 With the camera in the desired position, tap and hold an unused number for about 3 seconds to
save the preset.
NOTE
If you select a number to save a camera preset to and another camera preset is already saved to that number,
the new camera preset replaces the original one.
----End
Follow-up Procedure
On the Control Camera screen, tap a preset number to apply that preset to the camera.
4.4 Switching Between Screen Layouts
Available screen layouts are full screen, Picture in Picture (PiP), two panes, and three panes.
Table 4-2 describes the buttons to switch between screen layouts.
Table 4-2 Screen layouts switching buttons
Butto
n
Description Butto
n
Description
/
/
Switches the screen layout to
full screen.
The video feed displayed in
full screen can be
presentation, remote video,
and local video.
Switches the screen layout to PiP.
Switches the screen layout to
two panes.
Switches the screen layout to three panes.
NOTE
The three-pane mode is available during conferences only when there is a presentation being shared.
The available screen layouts depend on whether you are in a conference:
l If you are not in a conference and a presentation source is plugged in, tap buttons in the
screen layout control area (shown in Figure 4-1) on the home screen to display the local
video and presentation in full screen, two panes, or three panes.
l If you are in a conference, tap buttons in the screen layout control area to display the local
and remote video in full screen, two panes, or three panes. If a presentation is being shared,
HUAWEI 9000 HD Video Terminal Touch Panel
User Guide 4 Controlling What You See
Issue 01 (2012-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
23