Huawei AR160 Series - Optional) Installing a Cable Management Strip and a Protective Unit

1. Rotate the ejector levers on the power module outward and slide the power module into
the slot along the guide rails until the power module is completely attached to the router
panel.
2. Rotate the ejector levers inward to lock the power module in the slot.
3. Use a Phillips screwdriver to tighten the captive screws on the power module.
a
c
b
----End
7.4 (Optional) Installing a Cable Management Strip and a
Protective Unit
Context
If unshielded network cables are used as E&M trunk cables and need to be lead outdoors,
install a cable management strip on the cabinet and install protective units on the cable
management strip.
Tools and Accessories
l Impact tool
l Diagonal pliers
l Phillips screwdriver
l Cable management strip holder
l Cable management strip
l Protective units
l M6 screws
NOTE
The cable management strip holder, cable management strip, protective units, and M6 screws are not
included in the installation accessory package delivered with a card and need to be purchased separately.
Procedure
Step 1 Use a Phillips screwdriver and M6 screws to fix the cable management strip holder onto
mounting rails of the cabinet, as shown in Figure 7-5.
Huawei
AR100&AR120&AR150&AR160&AR200&AR1200&AR
1600&AR2200&AR3200&AR3600 series Enterprise
Routers
Hardware Installation and Maintenance Guide
7 Installing AR2240/AR2240C/AR3260/AR3670 Routers
Issue 05 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
105