Huawei AR160 Series - Page 99

NOTICE
l Do not power on a router before you finish connecting power cables and network cables.
l Each router has its own power cables delivered as accessories. The power cables can only
be used on the router in the same package and cannot be used on any other device.
NOTE
The AC power cable parameters vary in different countries or regions. The figures in this section are for
reference only and may differ from the cables delivered.
Tools and Accessories
l ESD wrist strap
l AC Power Cable
l AC terminal locking latch
Procedure
Step 1 Verify that the router is reliably grounded.
Step 2 Set the power switch to OFF.
Step 3 Wear an ESD wrist strap. Ensure that the ESD wrist strap is grounded and in a close contact
with your wrist.
Step 4 Connect the AC power cable.
1. Connect one end of the AC power cable to the power socket on the router.
2. Connect the other end of the AC power cable to an AC power outlet.
~100-240V;50/60Hz;2A
FE0 FE1 FE2 FE3 FE4 FE5 FE6 FE7GE0 GE1
CON/AUX
EN EN
21
management
ON
OFF
AR1220
AC power outlet
AC Power Cable
Step 5 Connect the AC terminal locking latch.
1. Insert the AC terminal locking latch into the jack on the rear panel of the router.
2. Adjust the AC terminal locking latch to a proper position.
3. Lock the AC power cable with the AC terminal locking latch.
Huawei
AR100&AR120&AR150&AR160&AR200&AR1200&AR
1600&AR2200&AR3200&AR3600 series Enterprise
Routers
Hardware Installation and Maintenance Guide
6 Installing the AR1200 Series/AR2204/AR2220E/
AR2220/AR2204E Series Routers
Issue 05 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
93