l Password for logging in to the switch modules to be connected
Default password: Huawei12#$
Procedure
Step 1 Log in to the MM910 CLI by using PuTTY and the floating IP address of the MM910.
For details about how to use PuTTY, see 6.2 Logging In to the MM910 CLI Over a
Network Port by Using PuTTY.
Step 2 Log in to the SOL CLI.
telnet 0 1101
The command output is as follows:
*=====================================================================*
* Welcome to SMM SOL Server *
* Please log in with SMM account and password. *
*=====================================================================*
user name:
Step 3 Enter the user name and password.
The following information is displayed:
Log in Success!
*=================================================================================
==========================
please input the SOL Blade1~Blade16(1 ~ 16), Blade1A~Blade16A(17 ~ 32),
Swi1~Swi4(33 ~ 36) and COM#(n)
press Ctrl+R to return
*=================================================================================
==========================
Blade1~Blade16(1 ~ 16)
Blade1A~Blade16A(17 ~ 32)
Swi1~Swi4(33 ~ 36)
Please input your choice:
In the information displayed:
l The numbers 1 to 32 indicate the compute nodes in slots 1 to 32 respectively.
l The numbers 33 to 36 indicate the switch modules in slots 1E, 2X, 3X, and 4E
respectively.
Step 4 Enter the slot number of the switch module, and press Enter.
l The secreen for selecting the serial port is displayed.
NOTE
For details about the serial port options, see Table 2-2.
l If an SOL connection has been connected through the serial port, a message will be
displayed asking you whether to forcibly disconnect the existing SOL connection.
CX320 Switch Module
User Guide
6 Common Operations
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 83
To Next Page
Loading...
Need help?
General
