– Press Y to forcibly disconnect the existing SOL connection.
– Press N to not disconnect the existing SOL connection. The system stays at the
current screen.
Step 5 Enter the number of a serial port, and press Enter.
l The serial port CLI is displayed. On this CLI, you can perform operations such as
configuring the serial port and querying parameters of the serial port.
l If another user has logged in to the serial port, a message will be displayed asking you
whether to forcibly log out the user.
– Press Y to forcibly log out the user.
– Press N to not forcibly log out the user. The system stays at the current screen.
CX320 Switch Module
User Guide
6 Common Operations
Issue 09 (2019-08-02) Copyright © Huawei Technologies Co., Ltd. 84
To Next Page
Loading...
