Huawei OptiXRTN 980L - Elliptical Waveguide: Clamp Installation; Installing Waveguide Clamps

Installing Clamps
b
Install clamps.
1
a. Assembling fixture
b. Screw
Secure the elliptical waveguide
2
8 mm ( 0.3in )
•Install clamps at 1 m ( 3.28ft ) intervals in the horizontal or vertical direction.
•Install clamps at the two ends of each bent part.
a. Install a clamp onto the elliptic
waveguide.
b. Tighten the screw on the clamp until the gap
is 8 mm ( 0.3in ).
38