SUN2000 (8KTL-28KTL)
User Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Positive and negative metal terminals are packed with positive and negative connectors
respectively. Separate the positive from negative metal terminals after unpacking the
SUN2000 to avoid confusing the polarities.
Procedure
Step 1 Remove cable glands from the positive and negative connectors.
Step 2 Remove the insulation layer with an appropriate length from the positive and negative power
cables by using a wire stripper as show in Figure 5-19.
PV power cables with a cross-sectional area of 4 mm
2
are recommended.
Cables with high rigidity, such as armored cables, are not recommended, because poor contact
may be caused by the bending of the cables.
Figure 5-19 Connecting DC input power cables (1)
To Next Page
Loading...
