Huawei SUN2000-4.95KTL-JPL1

To Next Page

To Previous Page

No. Label Denition Description

3 CT2+ Primary

CT2+

W wire on the power grid side

4 CT2- Primary

CT2–

5 CT3+ Reserved N/A

6 CT3-

7 CT4+

8 CT4-

Procedure

Step 1 Route the CT cable terminals into the maintenance compartment through the

cable hole at the bottom of the SUN2000, connect the CT terminals based on the

cable labels.

Step 2 Locate the SUN2000 CT terminal in the

tting bag.

Step 3 Connect the prepared cord end terminals to the corresponding ports of the CT

terminal, and insert the communications terminal into the CT terminal base of the

SUN2000.

Figure 5-29 Connect the CT and CT cables

SUN2000-4.95KTL-JPL1

User Manual 5 Electrical Connections

Huawei SUN2000-4.95KTL-JPL1 - Page 66