Huawei UPS5000-E-200K-SM - UPS Cable Connection Reference

UPS5000-E-(50 kVA-300 kVA)
User Manual (50 kVA Power Modules)
3 Installation
Issue 02 (2017-02-25)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
69
3.2.4 UPS Cable Connection Reference
Procedure
Step 1 Route a cable into the cabinet and bind it to a nearby beam.
Step 2 Pull the cable to the copper bar to which the cable will be connected, determine the cable
length, and label the cable.

Mark a line where the cable is to be cut.

Mark a line where the cable is to be stripped and an OT/DT terminal is to be crimped.
Step 3 Pull the cable that has been marked out of the cabinet, cut the cable from the marked position,
and strip the cable and crimp an OT/DT terminal at the other marked position.
Step 4 Connect the cable with a crimped OT/DT terminal to the corresponding copper bar.