SR05-D1A3-PV manual v1801 2/83
Warning statements
Putting more than 30 Volt across the sensor wiring
of the main power supply can lead to permanent
damage to the sensor.
Keep the voltage on the RS-485 data wiring of
SR05-D1A3-PV between -7 and +12 V to avoid
permanent damage.
For proper instrument grounding: use SR05 with its
original factory-made SR05 cable.
Using the same Modbus address for more than one
device will lead to irregular behaviour of the entire
network.
Disconnect power while performing service or
maintenance.
Locally connect the cable shield to ground if
SR05-D1A3-PV is not connected to ground through
the installation platform.
Modbus
®
is a registered trademark of Schneider Electric, licensed to the Modbus Organization, Inc.
To Next Page
Loading...