SR05-D1A3-PV manual v1801 66/83
9 Appendices
9.1 Appendix on cable extension / replacement
The sensor cable of the SR05 series is equipped with a M12-A straight connector. In case
of cable replacement, it is recommended to purchase a new cable with connector at
Hukseflux. In case of cable extension, it is recommended to purchase an extension cable
with connector pairs at Hukseflux. Please note that Hukseflux does not provide support
for Do-It-Yourself connector and cable assembly.
SR05 is equipped with one cable. Maximum length of the sensor cable is recommended
to be 40 metres. It is good practice to keep the length of the instrument as short as
possible to avoid inference of the signal and keep noise at acceptable levels.
Do not use SR05’s original factory-made cables with a total length of more than 40
metres.
Connector and cable specifications are summarised on the next page.
Connector and cable specifications are summarised on the next page.
Figure 9.1.1 On the left the SR05 cable with M12-A female connector on sensor end.
The cable is non-stripped on the other end. Its length is 3 metres standard and available
in 10 and 20 metres too. On the right Hukseflux extension cable with connector pairs,
with male and female M12-A connectors, available in 10 and 20 metres.
To Next Page
Loading...