Hukseflux SR05 series - Appendix On Tools for SR05; Appendix On Spare Parts for SR05

To Next Page

To Previous Page

SR05-D1A3-PV manual v1801 68/83

9.2 Appendix on tools for SR05

Table 9.2.1 Specifications of tools for SR05

CONFIGURATION

TOOLS INCLUDED

tooling required for mounting SR05

without ball levelling

two M5 bolts

applicable screwdriver

tooling required for mounting SR05

with ball levelling

hex key 4 mm

wrench size 8 mm for M5 nuts

yes

tooling required for mounting SR05

with tube mount

hex key 4 mm

yes

tooling required for levelling SR05

with ball levelling and tube mount

hex key 4 mm

yes

tooling required for tipping the aluminium

shim out of SR05’s bottom panel position

screwdriver blade width 2 to 4

9.3 Appendix on spare parts for SR05

• SR05 cable with female M12-A connector on sensor end, non-stripped on other end

(3, 10, 20 m). Specify cable length

• SR05 extension cable with connector pair, with male and female M12-A connectors,

(10, 20 m). Specify extension cable length

• Ball levelling (order number BL01)

• Tube mount (order number TM01)

• Tube mount with ball levelling (order number TMBL01)

• Shim for ball levelling mount

• Countersunk set screw for ball levelling mount

• 2 x M5x40 mounting bolts

• 2 x M5x30 mounting bolts

• 2 x M5x20 mounting bolts with 2 x M5 nuts

• Desiccant (silica gel, 1.0 g, in a HDPE bag)

NOTE: Dome, bubble level and sensor of SR05 cannot be supplied as spare parts