SR05-D1A3-PV manual v1801 31/83
4) Pinch the shim slightly in order to reduce its diameter and to make it fit easily into
SR05’s bottom plate.
5) While pinching, push the shim into its position on SR05’s bottom plate.
The shim is placed. For mounting and levelling, continue with the following steps:
6) Mount the ball levelling with its mounting bolts.
7) SR05, with its shim positioned, can now be placed on the ball levelling mount.
Gently push the sensor onto the ball head until it clicks.
8) The ball head can be rotated 360 ° and allows angle compensation on non-
horizontal surfaces up to 10 °.
9) When SR05 is mounted and levelled, judging by its bubble level, lock the ball head
mechanism by turning the set screw clockwise with a 4 mm hex key until it is
tightened. The set screw should be countersunk and not protruding (not sticking
out).
When the ball head is not inserted in SR05, the shim makes a minor rattling noise when
moving SR05. This is normal, caused by mechanical freedom between the two parts.
The shim can be removed from SR05’s bottom plate by hand with the assistance of a
small flathead screwdriver. See the chapter on tooling required. Let the screwdriver
gently tip the shim out. When removing or placing the shim, make sure the glass dome is
protected at all times.
To Next Page
Loading...