4. Push and pull on the jack and retighten if
necessary to make sure the jack is secure.
5. Place the wheel blocks in the tool bag.
6. Place the remaining tools in the tool bag.
7. Make sure nothing is located under or
in front of the seat and then lift the rear
driver’s seat so that the floor is exposed.
See 60/40 Split Bench Seat on page 15 for
more information.
8. Place the narrow end of the tool bag under
the seat rails as shown and slide the tool
bag under the rear seat.
Be careful not to pinch the seat cables or
electrical harnesses.
9. Reinstall the strap to the seat rail for the tool
bag. Wrap the strap around the seat rail and
then secure it to the tool bag.
10. Return the seat to the correct position. See
60/40 Split Bench Seat on page 15 for more
information.
487
To Next Page
Loading...
