Hunter Douglas Paramount - Mount the Installation Brackets - Outside Mount

INSTALLATION
9
Mount the Installation Brackets — Outside Mount
■ Mark 2" to 4" in from each jamb.
➤ If more than two “L” installation brackets came with your order, space additional
bracket(s) evenly in 24" to 30" intervals between the end brackets and mark their
location. Mount into wood whenever possible.
➤ Adjust mounting clips to allow
1
/
2
" clearance between the vane and the wall (i.e. 2
1
/
4
"
for 3
1
/
2
" vane).
■ Drill the screw holes using a
3
∕
32
" drill bit.
WARNING: Product is heavy. Mount into wood/metal studs or into concrete with
concrete anchors. Drywall anchors are not recommended.
■ Attach the brackets using the screws provided.
■ Center headrail underneath mounting clips.
■ Tilt the headrail and insert it into the front edge of the mounting clip. Pull and roll the
headrail up toward the rear of the blind and snap into place.
2 to 4"
2 to 4"
30" Maximum
30" Maximum
Tilt and
Pull Forward
Tilt and
Pull F
orward
Roll Back
Roll Back
Rear
Tab
Paramount
®
Headrail
PermaTrak
®
and PermAlign
®
Headrail
Push Up
Push Up
Rear
Tab