Hunter Douglas Paramount - Cord Adjustment-Cord and Chain Only

INSTALLATION
12
Cord Adjustment―Cord and Chain Only
NOTE: Cord length and/or tension cannot be adjusted for PermaTilt
®
Wand Control System. It
is set in the factory to help ensure that the product meets cord safety standard.
To reduce cord length on a Side Draw Blind:
■ Open the blind.
■ Release the cord tensioner by removing the screws.
■ Locate the cord knot in the front of the
lead carrier.
■ Pull the cord to the desired length.
■ Tie a double knot.
■ Re-install the cord tensioner with the screws.
■ Test for proper cord tension.
■ Cut the excess cord.
To reduce cord length on Center Draw Blinds:
■ Release the cord tensioner by removing the screws.
■ Place the blind in the closed position.
■ Locate the cord ends in the front of the lead carrier.
■ Select the cord knot that adjusts the cord length only; if carrier movement is observed,
select the other cord.
CAUTION: Cutting the wrong cord will cause irreparable damage.
■ Pull the cord to the desired length.
■ Tie a double knot.
■ Re-install the cord tensioner with the screws.
■ Test for proper cord tension.
■ Cut the excess cord.
Side Draw Carriers
in the Open P
osition
Cord Knot
Center Draw Carriers
in the Closed P
osition
Cord Knot