To Next PageTo Next PageWhat to do if Hunter Douglas PowerView Window Blinds slat pack appears skewed?
If the slat pack of your Hunter Douglas window blinds appears skewed toward the cordlock side, especially in an inside mount installation, slide the headrail in the end brackets in the opposite direction of the skew. Then, adjust the tabs in the end brackets to maintain the position of the unit. This will center the slat pack in the window.
Why is the bottom rail on my Hunter Douglas PowerView Window Blinds not raising or lowering completely?
If the bottom rail on your Hunter Douglas PowerView Window Blinds shade isn't raising or lowering completely, or its position has changed, the batteries in the battery wand or satellite battery pack may be low, so try replacing them. Also, make sure the battery wand, satellite battery pack, or 18V DC power supply is securely connected to the power cable, and that the cables aren't pinched or caught in the headrail or installation brackets.
What to do if Hunter Douglas PowerView Window Blinds shade is not responding to the remote?
If your Hunter Douglas PowerView Window Blinds shade isn't responding to the remote, first check that the correct group number is selected. Then, check that the batteries in the remote are correctly inserted and are fresh. The LEDs that backlight the remote should light up fully when you press STOP.
Why do Hunter Douglas PowerView raise unevenly?
If your Hunter Douglas Window Blinds raise or lower unevenly, the fabric rubs, or the bottom rail is uneven, check that the window is square by measuring the diagonals. Also, ensure the installation brackets are level, using shims if necessary. You can also adjust the bottom rail weight (though this doesn't apply to LiteRise® shadings).
What to do if Hunter Douglas PowerView Window Blinds vanes do not open?
If the vanes on your Hunter Douglas Window Blinds don't open when you first use them, try opening and closing the shading several times. If needed, gently pull down on the bottom rail when the shading is fully lowered.
What to do if SimpleLift Hunter Douglas PowerView Window Blinds make a ratcheting noise?
If your SimpleLift Hunter Douglas window blind makes a ratcheting noise while raising the bottom rail, push harder on the center button. The button must be fully depressed to properly raise or lower the blind.
Why are my Hunter Douglas PowerView Window Blinds decorative tapes wrinkled?
If the decorative tapes on your Hunter Douglas window blinds are wrinkled after installation, use a steamer to steam out the wrinkles. Wave the steamer in front of the tapes for a few seconds, being careful not to touch the slats. Avoid pulling down on the bottom rail while steaming to prevent stretching the tapes.
What to do if SimpleLift Hunter Douglas Window Blinds slats are not stacking evenly?
If, when raising your SimpleLift Hunter Douglas window blind, the slats are not stacking evenly and are falling over the bottom rail, it means the blind was raised too quickly. Gently raise the bottom rail to give the lift cords time to retract, allowing the slats to stack evenly.
How to replace batteries in Hunter Douglas PowerView Window Blinds battery wand?
To replace the batteries in your Hunter Douglas window blinds battery wand, squeeze the cap latch to release and remove the cap. Install the batteries according to the instructions on the battery wand label. Then, press the cap back on until it latches. Hunter Douglas recommends AA alkaline batteries for optimal performance. Lithium and rechargeable batteries are not recommended.
Why are my Hunter Douglas PowerView operating slowly?
If your Hunter Douglas window blinds are operating slowly or not tilting completely, the batteries in the battery wand, satellite battery wand, or C-size battery wand may be low. Replace the batteries. Also, check that the battery wand, satellite battery wand, C-size satellite battery wand, or 18V DC power supply is securely connected to the power cable and that the cables are not pinched. If the problem persists, the blind may need to be reset.
General| Control Method | Remote control, smartphone app, voice control |
|---|---|
| Connectivity | Wi-Fi, Bluetooth |
| Power Source | Battery-powered |
| Integration | Amazon Alexa, Google Assistant, Apple HomeKit |
| Scheduling | Yes |
| Scene Control | Yes |
| Battery Life | Approximately 1 year depending on usage |
| Compatibility | Hunter Douglas blinds and shades |
| App Features | Remote access, scheduling, scene control, integration with smart home systems |
