INSTALLATION
9
Final Adjustments
Adjust the Cord Length for UltraGlide
®
2 Click and Walk Away
™
(Silhouette
®
)
and UltraGlide (Nantucket
™
) Only
Adjusting the tassel to eye level will decrease the amount of pulls needed to raise and lower
theshading. This will also enhance child safety.
To Shorten the Tassel Cord
■ Grasp both parts of the tassel (the colored cover and
the frosted body).
■ Squeeze the tassel cover with your thumb and forefinger
(at the “S” of the HunterDouglas logo).
■ Separate and slide the tassel cover from
the tassel body.
■ Pull out the knotted end of the tasselcord.
■ Retie the cord at the desired shorter length, using a
double knot.
■ Trim the tassel cord.
■ Pull the trimmed knot up inside the tassel.
■ Squeeze the sides of the tassel cover together while sliding it back onto the tassel body.
Important: After reassembling, be sure there are no gaps between the two components.
Check that they do not pull apart easily. The tassel cover should be securely seated into the
tassel body.
Tassel
Cover
T
Cord
Tassel
Body
To Next Page
Loading...
Need help?
General
