INSTALLATION
10
Attach the Magnetic Hold-Down Brackets (Optional)
■ Lower the shading, keeping the vanes closed.
■ Place the magnetic hold-down bracket onto the bottom rail just inside
the end cap, oriented as shown.
■ Hold the bracket while opening and closing the vanes (it may be
necessary to have someone assist you). Adjust the bracket to the best
overall position.
■ Mark the screw location using the mounting options shown below.
➤ The screw should be placed in the middle of the channel. This will
allow for adjustment.
■ Drill the screw holes using a
3
/
32
" drill bit.
Important: Use drywall anchors when mounting into drywall.
■ Attach the hold-down brackets to the mounting surface using
the screws provided.
■ If necessary, adjust bracket height by loosening the screw and
sliding the bracket up or down.
Hold-Down
Bracket
Rail
Preferred Alternate
Preferred Alternate
Adjust bracket
height by
loosening the
the bracket up or
down.
To Next Page
Loading...
Need help?
General
