OPERATION
14
UltraGlide
®
Shadings (Nantucket
TM
Only)
To Lower the Shading and Open the Vanes
■ Pull the cord down toward the center of the
shading with long strokes.
■ Allow the cord to retract completely into the
headrail after each downward stroke.
■ Continue until the shading is fully lowered
and the vanes are open.
■ The shading can be stopped at any point
whilelowering by moving the cord back
toward the vertical position.
To Tilt the Vanes and Raise the Shading
■ Pull the cord straight down or
down and slightly out with long
strokes.
■ With each stroke the shading
partially raises.
■ Allow the cord to retract
completely into the headrail
after each downward stroke.
■ Use multiple strokes until the
shading reaches the desired
position.
■ The shading can be stopped at any point
while raising.
Lower
and Open
Vanes by
Pulling to
Center
Tilt
Vanes and
Raise by
Pulling
Straight
Down or
Down and
Slightly Out
or
To Next Page
Loading...
Need help?
General
