OPERATION
17
Problem The shading raises or lowers unevenly or the bottom rail is uneven when
fully raised.
Solution Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level, ifnecessary.
Adjust the bottom rail weight (not applicable for LiteRise
®
shadings). See below.
For LiteRise Only: Keep the bottom rail level while raising the shading. Side-
to-side movement while raising may cause the fabric to skew.
Problem The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fullyraised.
Solution Check that the installation brackets are level. Shim to level, ifnecessary.
Adjust the bottom rail weight (not applicable for LiteRise shadings). See below.
Adjusting the Bottom Rail Weight
■ To release the weight clip, insert a flat blade screwdriver into the weight clip
and turn clockwise.
■ Move the weight in 1" increments toward the side
where the fabric isgathering.
■ Secure the weight clips in position by turning them
counterclockwise after making the adjustment.
■ Test and, if necessary, adjust again.
Problem EasyRise
™
Shadings Only: The universal cord tensioner has climbed to the
headrail.
Solution Pull down on the spring to relieve tension and pull the universal cord tensioner
to the bottom of the cord loop. Properly mount the cord tensioner. See the
Universal Cord Tensioner Installation Instructions included with your shading.
Weight
Weight
Clip
Weight
Clip
Move Weight
To Next Page
Loading...
Need help?
General
